Adding a Serialized Kit on TH6 Mobile

Updated by Cheryl Wallace

  1. Tap Inventory then tap Serialized Kits.
  2. Tap ​​ to add a new serialized kit.
  3. Enter the identifying information for the kit.
    1. Enter the Primary ID for the new serialized kit. Type the item ID or tap to scan the barcode or QR code.
    2. Select the Part No for the kit. Type or tap to scan the part number. Use to search if the Part Number is not known. The general information will be populated including the Inventory Status, Stocking Point, Description, Inventory Type, and whether this is a Dissolvable kit.
  4. Tap the Contents tab.
  5. Add each component to the kit.
    1. Type the item ID in Add Kit Content, or tap to scan or tap to search. The item ID, Part No, and Description are added in the grid below as being required for the kit. The Required Qty defaults to 1.
    2. Modify the Required Qty if required for non-serialized inventory. For serialized items, the Required Qty must be 1. The Balance will show the shortage.
    3. Move the inventory into the kit by entering the Quantity.

    Any serialized items in the kit will now have a Kit ID link to this kit and the QOH will be 0.

    The stocking point for the item will reflect this quantity in the In Kit column

    Any bulk or consumable items in the kit will have the QOH reduced by the quantity adjusted into the kit.

    The stocking point for the item will reflect this quantity in the In Kit column

  6. Tap to save the changes to the kit.

See also:

​Copyright © 2020-2024 ToolHound Inc. All Rights Reserved.

How did we do?